Freestyle Watch FS81200 User Manual

LIMITED LIFETIME WARRANTY  
Freestyle U.S.A. warrants, to the  
original purchaser, that its watches  
are free from defects in materials  
and workmanship for the lifetime  
of the watch (under normal use)  
from date of original purchase.  
The following are not covered under  
warranty: battery, strap/bracelet/  
band and crystal.  
1. Press S3 button to select time mode.  
2. Press S2 button to toggle between  
HOME TIME and FOREIGN TIME  
mode to set.  
3. Press and hold S2 button for two  
seconds until the “SETmessage  
appears and the second digits blink.  
4. Press S1 button to reset the second  
digits to 00.  
5. Press S3 button, the minute digits  
will blink.  
6. Press S1 button to set the minute  
digits. Holding down the button will  
speed up the process.  
alarm. Alarm indicator  
will appear.  
3. Press again to activate the hourly  
chime. Chime indicator will  
appear.  
4. Press the third time to activate both  
functions. Both of the indicators will  
appear.  
5. Press the fourth time to deactivate  
both functions. Both of the  
indicators will disappear.  
TO SET THE TIMER  
1. Press S3 button to select TIMER  
mode.  
FOLLOW THESE 8 TIPS TO GET THE  
MOST OUT OF YOUR NEW WATCH!  
2. Press S2 button to alter the timer  
setting among 1, 3, 5, 10, 15, 20, 25,  
30, 45 and 60 minutes.  
1. Never pull out the crown or operate  
the pushers/buttons under water.  
TO USE THE TIMER  
In TIMER mode,  
CONVERT  
2. Make sure your crown is returned  
to the original position before you  
expose your watch to water.  
1. Press S1 button to start counting.  
2. To stop counting, press S1 button  
once. Press S1 button again to  
resume from where it left off.  
3. To reload the TIMER, press S1  
button to stop counting and then  
press S2 button.  
4. After reaching zero in a countdown,  
a tune will be emitted. To stop the  
tune, press any button, the TIMER  
will reload automatically.  
Accidental breakage or damage  
due to normal wear or misuse of  
the product, including but not limited  
to the mathematical accuracy of  
the product, is not covered under  
this warranty. Some states do not  
allow limitations on how long an  
implied warranty lasts, or the  
exclusions of or limitations on  
consequential damages, so the  
above limitation may not apply to  
you. This warranty gives you  
Model FS81200  
Model FS81201  
WHEN AN ALARM OR HOURLY  
3. If your watch is exposed to  
saltwater it is very important to  
wash it thoroughly under tap water  
and wipe dry with a soft cloth.  
Keep it clean!  
CHIME GOES OFF  
A tune will go off by the hour if the  
hourly chime function is activated.  
FEATURES  
100 meters H2O  
Day/date  
EL backlight  
Chronograph  
Pre-set countdown timer  
Alarm  
7. Press S3 button, the hour digits will  
blink.  
8. Press S1 button to set the hour  
digits.  
An alarm tune will be emitted for  
around 20 seconds at the designated  
time when the alarm is activated. To  
stop the tune, press any button.  
9. Follow the same pattern to set date,  
month, day (of the week), hour  
format and calendar format.  
10.To set the hour format, press S1  
button to toggle between 12-hour  
and 24-hour format. The P.M.  
indicator may be displayed to  
indicate the time period 12:00A.M.  
– 11:59 P.M. in 12-hour format.  
11.To set the calendar format, press  
S1 button to toggle between M-D  
(month-date) and D-M (date-month)  
format.  
4. Severe impacts or drops may  
affect your watches water  
resistance and performance.  
Dual time  
NOTE: You can leave the timer running  
while switching over to other operating  
modes.  
specific legal rights, and you may  
have other rights, which vary from  
state to state.  
5. Avoid exposing your Freestyle  
watch to extreme temperatures  
such as in a hot shower, Jacuzzi,  
sauna or hot tub. The combination  
of extreme heat and water may  
cause your watch to lose some of  
its water resistance.  
TO USE THE STOPWATCH  
1. Press S3 button to select  
STOPWATCH mode.  
2. The stopwatch will then be displayed  
in its current state – reset, running,  
or stopped.  
3. To resume a counting, press S1  
button to resume from where it left  
off.  
4. To start a new counting, reset the  
stopwatch to zero first.  
CONTROL BUTTONS  
S1 - Start/stop button  
S2 - Lap/reset button  
S3 - Mode button  
Under this warranty FREESTYLE  
will make any necessary repairs, if  
applicable, at no cost to you the  
consumer. Any repair needed that  
is not under warranty will be at the  
cost of you the consumer. Proof  
of purchase and / or original receipt  
it needed to validate your warranty.  
TO USE THE BACKLIGHT  
Press S4 button to turn on the backlight  
for around three seconds.  
S4 - Light button  
6. Avoid exposing your watch to  
chemicals, soaps or solvents as  
they deteriorate the water resist  
seals in your watch.  
12.After finish making all the settings,  
press S2 button to confirm.  
S4  
S3  
S1  
S2  
Press S1 button to stop counting,  
then press S2 button to reset  
counter to zero.  
Your warranty is voided by any  
servicing out by a non-authorized  
agent. Any other form of guarantee  
to you by the retailer is his / her  
responsibility. This warranty applies  
to watches purchased in the United  
States. For watches purchased  
outside the United States, please  
contact you authorized  
NOTE: The chosen hour and calendar  
formats will apply to both HOME TIME  
mode and FOREIGN TIME mode.  
7. Never try to remove the caseback,  
leave this to a certified watch repair  
technician or Freestyle service  
center. This will help in preventing  
water leakage from improper  
battery replacement.  
For the measurement of elapsed time:  
In STOPWATCH mode,  
1. Press S1 button to start counting.  
2. To stop counting, press S1 button  
once. Press S1 button again to  
resume from where it left off.  
3. To reset to zero, press S1 button to  
stop counting, then press S2 button  
to reset the counter to zero.  
NOTE: In FOREIGN TIME settings, only  
minutes, hours, date, month and day  
are open to setting.  
DISPLAY MODES  
The watch has four display modes:  
HOME TIME (TIME), HOME TIME  
ALARM (ALM1), STOPWATCH (STW)  
and COUNTDOWN TIMER (TMR).  
8. It is advisable to have your watch  
pressure tested annually and to  
re-furbish your watch every 2-3  
years to extend the life of the watch.  
TO SET THE ALARM TIME  
1. Press S3 button to select alarm  
mode.  
FREESTYLE dealer for warranty  
information.  
To change from one display mode to  
another, press S3 button once. The  
mode description will appear for 2  
seconds before the selected mode is  
activated.  
2. Press S2 button to toggle between  
HOME TIME ALARM and FOREIGN  
TIME ALARM mode to set.  
3. Press and hold S2 button for two  
seconds until the “SETmessage  
appears and the minute digits blink.  
4. Press S1 button to set the minute  
digits. Holding down the button will  
speed up the process.  
5. Press S3 button, the hour digits will  
blink.  
6. Press S1 button to set the hour  
digits.  
For the measurement of split time:  
In STOPWATCH mode,  
1. Press S1 button to start counting.  
2. While the stopwatch is running,  
press S2 button once to register a  
lap. The stopwatch is still running  
in the background.  
To display the currently accumulated  
time, press S2 button again.  
3. Repeat the last step until all the  
laps have been registered.  
4. To stop counting, press S1 button  
once. Press S1 button again to  
resume from where it left off.  
5. To reset to zero, press S1 button to  
stop counting, then press S2 button  
to reset the counter to zero.  
HOME AND FOREIGN DISPLAY  
To display FOREIGN TIME, press S2  
button when HOME TIME is displayed.  
The mode description (TM-2) will  
appear shortly before FOREIGN TIME  
is displayed. To change back to HOME  
TIME, press S2 button.  
7. After finish making all the settings,  
press S2 button to confirm.  
To display the daily FOREIGN TIME  
ALARM, press S2 button when HOME  
TIME ALARM is displayed. The mode  
description (ALM2) will appear shortly  
before FOREIGN TIME ALARM is  
displayed. To change back to HOME  
TIME ALARM, press S2 button.  
TO TURN ON/OFF THE ALARM  
AND HOURLY CHIME  
In alarm mode,  
1. Press S2 button to toggle between  
HOME TIME ALARM and FOREIGN  
TIME ALARM mode to set.  
NOTE: You can leave the stopwatch  
running while switching over to other  
operating modes.  
TO SET THE TIME AND  
CALENDAR  
2. Press S1 button once to activate the  
 

Edirol Computer Keyboard PC 50 User Manual
Elation Professional Work Light 15R PRO User Manual
Electro Voice Portable Speaker DMC 1122A User Manual
Electro Voice Portable Speaker SRO 18 User Manual
Fellowes Paper Shredder HD12CS User Manual
Frigidaire Microwave Oven FFCE2238LB User Manual
Fujitsu Printer KD96009 0648 User Manual
Garmin GPS Receiver Vista C User Manual
GarrettCom Switch 500 Series User Manual
Gefen Stereo Amplifier EXT AVSCALER PRO User Manual